Vermeiren Sigma Manuel D'utilisation page 20

EN
NL
3.7.2 Armrests
Position
The armrests can be turned backwards (up) to make it easier to
transfer to/from the seat.
1. Push lever (31) of the toothed clamp (30) slowly down. The arm
rest is unlocked (in bottom position).
2. Turn the armrest up/backwards to its end position.
3. Pull lever (31) up to close the toothed clamp. The armrest is
locked in end position.
Angle
The same procedure is used to change the angle of the
armrest:
1. Repeat previous step 1.
2. Next, hold the armrest in the desired position, while
locking it with the lever (31).
3. Repeat this for the second armrest.
4. Make sure that both armrests have the same angle.
5. Make sure that both armrests are firmly secured.
3.7.3 Arm pads
The arm pads (3) can be adjusted in height (stepless) and angle (7,5° step):
3
3.7.4 Footrest B06
To remove
1. Pull footrest lever (27) and swing footrest (4) outwards.
2. Lift the footrest to remove it.
To install
1. Hold footrest (4) sideways and hang it in footrest support
(28).
2. Swing the footrest inwards until it clicks in position.
1. Turn the star knob (32) a few turns anticlockwise. To
adjust the angle, turn it four turns minimally.
2. Pull/push the arm pad lightly to adjust the height.
3. Hold the arm pad at the desired angle.
4. Turn the star knob clockwise until it is finger-tight.
5. Repeat this for the second arm pad.
32
6. Make sure that both arm pads are firmly secured.
16
Sigma, Sigma 230
Using your wheelchair
12
31
4
28
27
2021-01
31
30