Technical Specifications; Putting The Machine Into Service - Grillo G85-D Manuel D'utilisation

reversible.
Track: external measurements: with tyres 4.00-8, 42 cm - with wide steel wheels, 36-44 cm.
Implements and attachments: tiller, double tiller, mower bar, snow thrower, plough, furrower,
lawn mower, grass shredder, irrigation pump, spraying pump, towed trailer, rotary tiller support
wheel, towing bar, wheel weights, metal wheels, weeder, container trailer, rake, front scraper,
biological grinding mill, sweeper.
ENGINE TYPES:
LOMBARDINI 15LD440 diesel engine
ROBIN SUBARU EX 27 petrol engine
Also available with electric system.
MACHINE:
Clutch: active clutch
Gearbox: 6 speeds – 3 forward + 3 reverse both as rotavator and as sickle-bar (turning the
handlebars). Speeds in km/h with engine at 3600 r.p.m. are as follows:
Ist REVERSE
IInd REVERSE
IIIrd REVERSE
P.T.O.: independent from the gearbox; 965 rpm with engine at 3600 rpm.
Wheels: tyres 4.00-8 /4.00-10 /5.00-10.
Rotary tiller: 58 cm standard; adjustable up to 37-47-68 cm.
Handlebar: Side and height adjustment - reversible.
Track: external measurements: with tyres 4.00-8, 42 cm - with wide steel wheels, 36-44 cm.
Implements and attachments: tiller, double tiller, mower bar, snow thrower, plough, furrower,
lawn mower, grass shredder, irrigation pump, spraying pump, towed trailer, rotary tiller support
wheel, towing bar, tank mounted on dolly, wheel weights, metal wheels, weeder, container trailer,
rake, front scraper, biological grinding mill, sweeper.
1) Check that the machine has not been damaged during transport.
2) Remove the walking tractor from the package, paying attention not to damage wires and levers.
Use a lifting machine (min. capacity: 200 kg). Before putting the machine on the ground mount the
wheels and make sure the nuts are well tightened (fig. 3, n. 8).
3) The walking tractor is delivered with the handlebar positioned over the engine (sickle-bar
version). To turn the handlebar to use the rotary tiller push the lever (fig. 3A, n. 12) and slowly turn
the handlebar 180° in anti-clockwise direction, paying attention not to force this mechanism and
not to damage wires. Then insert both the gear and PTO levers into the lower eyelets (fig. 3A for
G85-G85D and 3B for G107D).
4) Before connecting the implement, the PTO coupling of the machine has to be filled with grease.
Then mount the implement(e.g. tiller, plough...) and make sure the nuts are well tightened (fig. 4A,
n. 20).
5) Add engine oil (see the engine manual).
6) Add gearbox oil - fig. 6 (MP 80W90 oil, or international equivalent API GL5 oil, US MIL-L-2105D,
quantity 2,2 litres for G85 and 1,9 litres for G85D and G107D.
Translation of the Original Instructions
TECHNICAL SPECIFICATIONS G107D
Gears
Ist
IInd
IIIrd

PUTTING THE MACHINE INTO SERVICE

Speeds with tyres 4.00-10
7
1,2
2,2
3,3
1,2
2,2
3,3