Charging The Battery; Operation; Troubleshooting - LIVARNO home 1020-B Instructions D'utilisation Et Consignes De Sécurité

(top/bottom) to an angle of up to 180° (see
Fig� H)�
Loosen the wall bracket star knob
„
adjust the height of the Spotlight (see Fig�
H)�
When the desired position is obtained,
„
tighten the star knob again�
Loosen the Spotlight star knob
„
the angle (see Fig� H)�
When the desired position is obtained,
„
tighten the star knob again� If necessary,
use a screwdriver to hold the screw while
tightening the star knob�
Please note: the motion sensor has a field
of view of up to 120°� Make sure that the
motion sensor faces directly towards the
desired detection zone�
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
not dirty�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z Charging the battery
The battery is charged in all operating
„
modes� To optimise initial charging, charge
the product while it is turned off�
Please note: the battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours� The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight�
z Operation
The product can be operated in three
different modes� The operating mode is set
by means of the switch
Please note: the solar panel will turn on the
product in twilight or darkness in the mode
to
10
to adjust
9
is
2
�
5
you have set�
Please note: battery charging via the solar
panel does not depend on which mode is
selected� The battery is charged continuously
at all times�
Mode 1
Press and hold the switch
„
to switch to "Mode 1"�
The Spotlight will light up once and then
„
switch to guide-light function (reduced
brightness)�
If the motion sensor detects movement
„
within its range, the Spotlight will light up
at maximum brightness�
After approx� 15 seconds, it switches back
„
to guide-light function�
Mode 2
Press the switch
„ 5
"Mode 2"�
The light will flicker twice and then switch
„
off�
If the motion sensor detects movement
„
within its range, the Spotlight will light up
at maximum brightness�
After approx� 15 seconds, it will switch off
„
again�
Mode 3
Press the switch
„ 5
"Mode 3"�
The light will flicker 3 times. The guide-light
„
function (reduced brightness) is then
permanently active� The motion sensor is
inactive in this mode�
Switching off the Spotlight
To switch off the Spotlight, press the switch
„
for a fourth time�
5
z Troubleshooting
= Fault
= Cause
= Solution
for 3 seconds
5
again to switch to
again to switch to
GB/IE/NI
11