Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Preparation
Q
Required tools and materials
Q
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only. The nature of
the material depends on the individual circumstances
on site.
- Pencil / Marking tool
- Screwdriver
- Electric drill
- Drill (Ø 6 mm)
- Spirit level
- Measuring tape
Preparations for use
Q
Fitting the light
Q
Note: Prior to installation, verify there is a socket
nearby within reach of the included power cable
Note: The light can be set to 3 light levels using a
slide switch
.
9
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the distance for the mounting holes
or
.
6
3. Now drill the mounting holes (ø approx. 6 mm,
depth approx. 40 mm). Make sure that you do
not damage any electrical cables during this
operation.
4. Insert the supplied wall plugs
holes. Insert the supplied screws
wall plugs
and tighten them, stopping when
1
they project about 3 mm out of the wall or
mounting surface (Fig. A and B).
5. Attach the light using the appropriate mounting
holes
or
to the screws
3
6
6. When you have attached the light above the
assembly holes
, slide the light housing
3
to the left until it clicks into place.
7. Insert the light connector plug of the mains
8. Insert the mains plug of the mains lead
Q
CAUTION!
Please ensure all under-cupboard lamps have been
connected with the connection cable
connecting the mains plug
Note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
.
7
3
into the drilled
1
into the
2
.
2
5
Preparation / Preparations for use
lead
into the light connector socket
7
a convenient mains socket. Your light is now
ready for operation.
Connecting several
lights together (Fig. C)
12
Install up to 10 lights of the same model next
to each other. To do so, follow steps 1–5 of
the section called "Fitting the light".
Note: Make sure that the distance between
the lights is not more than 15 cm.
Note: Make sure that the distance between
the lights is not less than 10 cm.
Remove the protective head guard
Insert the connecting cable
necting socket
of the light.
11
Insert the second connection of the connecting
cable
into the socket
8
Insert the connection of the power cable
into the socket
of the outer, left-hand light.
4
Connect the mains plug
Your lights are now ready for operation.
Switch on the light /
change light color
To switch on the light, move the slide switch
to position I.
Move the slide switch
9
alter the colour of the light:
Position I - warm white
Position II - neutral white
Position III - cold white
.
4
into
12
before
8
to the mains socket.
.
10
into the con-
8
of the other light.
4
7
to the mains socket.
12
9
to position II or III to
GB/IE
17
Publicité
Chapitres
Table des Matières
