Mounting The Spotlight; Positioning The Spotlight; Solar Panel - LIVARNO home 1020-B Instructions D'utilisation Et Consignes De Sécurité

is a risk of serious or fatal injury from electric
shock�
Please note: the fixings included are
suitable for conventional solid masonry� You
should check independently what kind of
fixings are best suited for the surface on
which you intend to mount the light� If
necessary, you should seek the advice of an
expert�
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„
area� Make sure that the motion sensor
covers the desired area�
The motion sensor has a maximum
„
detection range of 10m with a field of view
of approx� 120°�
Ensure that the motion sensor
„
position where street lighting will shine on it
at night� This may impair the function�
The recommended installation height is 2 to
„
4m� If possible, mount the Spotlight in a
position where it will not be exposed to dirt
or dust and is protected from rain (e�g�
under a roof overhang) and other
weathering effects�
Please note: the solar panel
positioned where it will be exposed to as
much direct sunlight as possible� Even partial
shade during the day can significantly
impair the charging process�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z Mounting the Spotlight
Transfer the positions of the guide holes
„
/ to the mounting point on the wall�
13
Drill two holes (dia� 6mm) and insert the
„
matching wall plugs
G)�
10
GB/IE/NI
4
is not in a
4
should be
2
3
(see Figs� C and
8
Mounting model 1020-B
Screw the screws
„
7
leaving a gap of approx� 3mm between the
screw head and the wall (see Fig� C)�
Slot the guide holes
„
then slide the Spotlight along the guides to
fix it in place (see Fig. C).
If necessary, adjust the gap between the
„
screw heads and the mounting surface to
provide a firm seating for the Spotlight.
Mounting model 1020-S
Screw the wall bracket
„
by inserting the screws
guide holes into the wall plugs
13
firmly tightening them (see Fig. G).
Fix the Spotlight to the wall bracket
„
loosening the Spotlight star knob
removing the screw
Align the holes in the Spotlight with the
„
holes in the wall bracket and slot the screw
through the holes (see Fig� F)�
12
Screw the Spotlight star knob
„
screw and tighten it hand-tight� Check that
the product is fixed firmly in place.
z Positioning the Spotlight/

solar panel

Positioning model 1020-B
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig� D)�
Loosen the two Spotlight star knobs
„
adjust the Spotlight (see Fig� B)�
When the desired position is obtained,
„
tighten the star knobs again� If necessary,
use a screwdriver to hold the screw while
tightening the star knob�
Positioning model 1020-S
The Spotlight can be adjusted horizontally
into the wall plugs
8
over the screws and
3
firmly in place
11
through the
7
and
8
by
11
and
9
�
12
onto the
6
to
6
,