Cleanmaxx FJ142L Mode D'emploi page 22

EN
5. If necessary, thoroughly rinse out the HEPA fi lter with clean, lukewarm water.
Attention: Do not use any detergent!
Then shake off any leftover water and let the fi lter air dry completely before putting
it back in.
6. You can clean the cyclone insert and dust bin with a damp cloth.
7. Once all parts are dry, put the cyclone insert back in the dust bin.
8. Once it is dry, put the HEPA fi lter back in the holder on the cyclone insert. Close the
lid so that it audibly locks into place.
Attention: Do not in any case insert device parts that are still wet in the dust
bin!
9. Close the lid of the dust bin. It must audibly lock into place.
10. Insert the dust bin in the device. Make sure that it audibly locks into place.
Cleaning the motor fi lter
The motor fi lter is located behind a protective grate on the front of the vacuum cleaner.
E
Then shake off any leftover water and let the fi lter air dry completely before putting
it back in.
3. Brush or wipe out the fi lter compartment if necessary.
4. Insert the exhaust hatch with the fi lter in the device and close the hatch. The cover
must audibly lock into place.
Cleaning the suction tube and handle
• If necessary, thoroughly rinse out the suction tube with clean, lukewarm water.
22
2. Push the two release buttons on the dust bin to open the
C
lid of the dust bin. Fold it open.
3. Carefully take the HEPA fi lter (C) off of the cyclone insert
(D) and the cyclone insert out of the dust bin.
D
4. Beat all parts out over a rubbish bin and brush off any
loose dirt.
1. Pull the fastener (E) for the exhaust hatch with the fi lter
down and at the same time, take the hatch off.
2. Beat the fi lter out over a rubbish bin. If necessary, clean
it with a soft brush. You can also rinse the fi lter out under
clear, lukewarm water.
Attention: Do not use any detergent!
• Remove the handle (1) from the suction tube (2) by push-
ing the release button on the handle (F).
F
• Pull the suction tube out by pushing the release button on
the device (G).
G
Attention: The suction hose must not be located on the
holder (15) if you want to remove the suction tube. Also
take the suction nozzles out of the holder.