Battery Compartment; Adjusting Mono Handlebar; Height Adjustment; Grass Catcher Box - Viking MA 443 Manuel D'utilisation

9.2 Battery compartment

The battery compartment must
always remain closed during
operation.
Opening battery compartment:
● Press in retaining tab (1) slightly and
open cover (2) rearwards.
Closing battery compartment:
● Fold down cover (2) and ensure that
retaining tab (1) engages.

9.3 Adjusting mono handlebar

(MA 443 C)
Danger of pinching!
When actuating the detent lever,
always hold the upper handlebar
with one hand at its highest point.
Never place your fingers between
the handlebar and console (over
and under the detent lever).
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Hold the upper handlebar (2) with one
hand at its highest point and lift (relieve
load) slightly.
● Press the detent lever (1) downwards
and hold.
● Fold the handlebar (2) down forwards,
ensuring that the electric cable is not
damaged.
Working position (to push machine):
44
● Fold the handlebar (2) up rearwards
and ensure that the handlebar is fully
engaged.
12

Height adjustment:

The height of the mono handlebar can be
adjusted to 2 levels:
● Hold the upper handlebar (2) with one
hand at its highest point and lift (relieve
load) slightly.
● Press the detent lever (1) downwards
and hold.
● Move the handlebar (2) into the
required position.
● Release the detent lever (1) and ensure
that the handlebar is again fully
13
engaged.
9.4 Adjusting dual handlebar
(MA 443)
Danger of pinching!
The upper handlebar can be folded
down by releasing the quick release
caps. It should therefore always be
held with one hand at its highest
point.
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Hold the upper handlebar (2) with one
hand at its highest point.
● Open the quick-clamping devices (1) –
fold downwards – and fold the upper
handlebar (2) forwards, ensuring that
the electric cable is not damaged.
Working position (to push machine):
● Fold up the upper handlebar (2)
rearwards and hold with one hand.
● Close the quick-clamping devices (1) –
fold upwards.

9.5 Grass catcher box

Attaching:
● Open the discharge flap (1) and
hold it open.
● Attach the grass catcher box (2) to the
mountings (3) on the rear of machine by
means of the locating lugs.
● Close the discharge flap (1).
Detaching:
● Open the discharge flap (1) and hold it
open.
● Lift the grass catcher box (2) and
remove it rearwards.
14
● Close the discharge flap (1).
9.6 Central cutting height
adjustment
Six different cutting heights can be
set.
Level 1 = 25 mm
Level 6 = 75 mm
Setting the cutting height:
● Hold the handle (1), pull the lever (2)
upwards and hold.
15
16
0478 131 9922 D - EN