Attaching The Antenna - Amprobe LT-10 Mode D'emploi

• Do not allow lamp test probe or antenna to touch energized wires.
• To avoid damages to antenna and personal injury, do not attempt to
bend or use the antenna as a crowbar.
• Do not operate the instrument if the case or the battery door is open.
• Do not use if the instrument appears damaged or doesn't operate
properly. If in doubt, have the instrument serviced.
• The non-contact voltage function is always on. Test on a known live
source within the rated ac voltage range of the product, both before
and after use to ensure the instrument is in good working condition.
Test Functions and Indications:
Test
Lamp test
Pin test
Non-contact voltage detection

Attaching the Antenna

Make sure the switch is securely locked onto the probe before use.
Removing the Antenna
Indication
Visual
LED on
LED on
LED flashing
Switch
Figure 1: Attaching the antenna
1
Figure 2: Removing the antenna
2
6
Audio
None
Solid tone
Modulated beep