Changing The Battery In The Remote Control - Dometic DA20E Notice D'utilisation

DA20E
If the awning does not retract automatically
➤ Check the battery status of the wind sensor and replace if necessary, see
chapter "Changing the batteries in the wind sensor" on page 42.
➤ Test the wind sensor again.
➤ If the wind sensor does not work and the awning does not retract
automatically, reprogram it, see chapter "Reprogramming the wind
sensor" on page 45.
➤ Test the wind sensor again.
➤ If the wind sensor does not work after reprogramming, contact your
service partner.
6.5

Changing the battery in the remote control

I
NOTE
If the LED in the remote control does not light up after pressing one
of the buttons, the remote control battery is flat.
➤ Remove the screw (fig. 3 2, page 2) on the back of the remote control.
➤ Open the housing of the remote control.
➤ Remove the old battery from the holder.
➤ Insert the new CR2430 (3 V) battery type into the holder with the positive
terminal facing upwards.
➤ Reassemble the remote control.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of
them at collection points.
EN
Operating the awning
41