Dometic DA20E Notice D'utilisation page 45

DA20E
7.2 Programming the awning intermediate position
An intermediate limit may be programmed to open awning to a customised
position between the outer limit and closed position.
Program the intermediate position as follows:
➤ Briefly press the
✓ The awning travels into the selected position.
➤ When the awning reaches the desired position, briefly press the
button to stop travel.
➤ Press the
✓ The awning briefly moves twice, indicating intermediate position is
recognized.
I
NOTE
If you desire a different intermediate position, repeat the steps
above.
Testing the intermediate position
➤ Press the
✓ The awning travels to the programmed intermediate position.
7.3 Reprogramming the wind sensor
The wind sensor is set to motor and remote control by default. In the following
cases, the wind sensor needs to be reprogrammed:
If the wind sensor no longer responds
If the wind sensor has been replaced
After the motor and remote control have been reset.
In this case perform the step 1, and then go directly to step 3.
To reprogram the wind sensor, proceed as follows:
Step 1: Opening the cover of the sensor
➤ Briefly press the
✓ The awning extends all the way.
EN
or button.
button for approximately 5 seconds.
button briefly with the awning in any position.
button.
Adjusting the awning
45