Dometic DA20E Notice D'utilisation page 53

DA20E
Problem
Awning does not retract
automatically in strong
winds.
Awning retracts
automatically in light
winds.
Awning retracts
automatically after
30 minutes, even if it is
not windy.
Awning retracts
automatically after
60 minutes, even if it is
not windy.
Awning retracts
automatically after
60 minutes, even if it is
not windy and the wind
sensor is functioning
faultlessly.
EN
Possible cause
The batteries in the wind
sensor are flat.
The wind sensor is not
programmed properly.
The wind sensor is not
programmed properly.
The batteries in the wind
sensor are almost flat.
The LED for the wind
sensor is continuously lit
up (fig. 6 D, page 3).
Wind sensor is missing or
not properly attached
onto the base plate
The batteries in the wind
sensor are flat.
Wind sensor is defective. The wind sensor needs to be replaced.
Another sensor that isn't
mounted or present any
more is connected to the
awning drive.
Troubleshooting
Suggested remedy
Replace the batteries (see chapter
"Changing the batteries in the wind
sensor" on page 42).
Contact the service partner in the
respective country.
Contact the service partner in the
respective country.
Replace the batteries (see chapter
"Changing the batteries in the wind
sensor" on page 42).
Push the wind sensor onto the base
plate until it clicks into place.
Replace the batteries (see chapter
"Changing the batteries in the wind
sensor" on page 42).
Contact the service partner in the
respective country.
Delete all programmed sensors:
➤ Briefly press the programming
button (fig. 3 1, page 2) on the
back of the remote control until
the awning drive acknowledges by
briefly moving twice.
➤ Press the programming button (2) of
the wind sensor (fig. 6 D, page 3)
for 7 seconds until the awning drive
again acknowledges by briefly
moving twice.
The connection of all wind sensors
connected to the awning drive until now
are deleted.
Programme the wind sensor afresh (see
chapter "Reprogramming the wind
sensor" on page 45, step 1 an 3).
53