Dometic DA20E Notice D'utilisation page 49

DA20E
Step 5: Set the outer limit
➤ Keep pressing the
correct outer limit.
The fabric edges of the awning should not hang down and must be taut at
all ends.
I
NOTE
When you press a button for longer than 10 seconds, the awning
motor will stop. In this case, release the button and press it again
until the awning has moved to the correct outer limit.
Step 6: Complete the programming
➤ Press the
➤ Briefly press the
✓ The awning stops.
➤ Press and hold down the
briefly.
➤ Press the programming button (fig. 3 1, page 2) on the back of the
remote control.
✓ The awning briefly moves twice, indicating that the programming is
completed. Now it can be retracted and extended again by pressing the
and
➤ Reprogram the wind sensor, see chapter "Reprogramming the wind
sensor" on page 45.
➤ To check the awning function, see chapter "Retracting the awning" on
page 39 and chapter "Extending the awning" on page 39.
EN
or buttons until the awning moves to the
and buttons until the awning starts to retract.
button.
button again until the awning moves twice
buttons briefly.
Adjusting the awning
49