Marmitek GV20 Mode D'emploi page 6

your satellite receiver while viewing in another room. Simply point your original remote
control to the IR window on the front of your GV20 Receiver. The IR signal is now transmitted
by radio to the GV20 transmitter.
Set up is simple, ideally with 2 people. Use the mini IR emitter RX570 (optional) and connect
the small jack plug on the back of the Receiver (IR)
You have to place the IR transmitter LED in front of the IR sensor of the equipment you want
to control. For the best result you can experiment which position of the IR transmitter LED
works best.
If you have problems with the range, try to move the receiver and/or transmitter away from
your connected equipment. This can greatly increase performance of the radio transmission.
Copyright © Marmitek. The right is reserved to make technical modifications
6 MARMITEK