Marmitek GV20 Mode D'emploi page 5

If you have several A/V components:
If you have two or more A/V components (e.g. VCR, Cable box, Laserdisc or satellite receiver)
that you want to watch in another room, they will probably already been hooked up to the
local TV in series. To connect the GV20 Transmitter you just need to indentify the last
component in the chain and connect the Line OUT or scart to the GV20 Transmitter IN jacks.
2. SETTING UP THE MARMITEK GV20 RECEIVER
1. Connect a set of Audio/Video cables to the LINE OUT jacks [H+I] of your GV20 Receiver.
Connect the other end to your TV. If your TV has a Scart connector, you may use the
Scart adaptor provided; labelled: "Receiver".
2. Switch the Power slide switch on the side into the "OFF" position
3. Plug the supplied mains adaptor, labelled Receiver 9V, 400mA, into a 230Volt -50Hz wall
outlet and connect the jack [E] to the 9V jack at the backside of the receiver. Only use the
supplied mains adaptor!
4. Switch the Power switch [B] to the ON position.
5. Set the Channel-switch [A] on A.
6. Put the side antenna [J] of the remote control extender in an upright position.
3. FINE TUNING YOUR MARMITEK GV20 SET
Make sure your A/V equipment is switched on. Switch the receiving TV on and select the A/V
channel (normally found on the "0" or "AV" button). The picture should now automatically
be there, no tuning is required.
The wireless GV20 usually works best with the indented faces of the antennas [K] on the
Transmitter and Receiver unit look at one another. Sometimes however distance, reflections
and other effects in the home may affect the signal so that some adjustment of either
Transmitter or Receiver antenna may be necessary to get the best signal.
If still experiencing difficulty, try changing the "ABCD" channel selector and change channels.
Remember though both the receiver and transmitter must be on the same channel.
If you are not getting any signal at all:
Check that the units are connected to mains and that the Power-switch is in the ON position.
Check that the Channel slide switch (labelled A-D) on both GV20 units is set at the same
number. Check if the receiving TV is on the correct A/V channel. Raise the small black side
antenna [J] to an upright position.
4. THE REMOTE EXTENDER
FEATURE
To use this feature, you need the
Marmitek RX570 IR Extender, separately
available (Art. No. 08920)
Your Marmitek VideoSender has the ability to transmit
infrared signals from your own remote control from
your receiving TV back to the equipment connected to
videosender. For example, you can change channels on
PC TO TV SENDER
Marmitek
art.no. 08920
5