Saving The Adjustment Data - Sony VPH-G70Q Manuel D'installation

Saving the Adjustment Data

Memory structure
The memory structure of this projector consists of three memory blocks
and a normal adjustment data block.
Factory data
block
Save as the
service
data.
Service data
block
Factory data block: The ten basic adjustment data for different types of
signals shown in the table on page 106 (EN) are preset at the factory.
The adjustment data in this block cannot be changed.
Service data block: The ten basic adjustment data for different types of
signals shown in the table on page106 (EN) are preset at the factory.
The data saved in the user data block can be saved as the service data.
User data block: The ten basic adjustment data for different types of
signals shown in the table on page106 (EN) are preset at the factory.
When a new signal is input, the data that has the nearest frequency is
automatically selected from among the ten basic data and the existing
data saved as input memory and loaded. If any of the data for the signal
is adjusted, the data is saved as an input memory in one of the memory
numbers 00 to 99. (If no data is adjusted, it is not saved.)
The adjustment data for each input signal, if any one of the signal input
conditions–vertical or horizontal frequency, type of sync signal, type of
input signal and input connector–is different, is saved in different
memory number as an individual input memory.
The memory number of the loaded data and that of the saved data are
displayed as "INPUT MEMORY No." on the INPUT INFO menu.
If the same signal has already been input, the same memory number
appears on two rows.
f H : 3 1 . 4 K H z
INPUT
SELECT f V : 5 9 . 9 H z
H / C - S Y N C : P O S
PIC
CTRL V - S Y N C : P O S
S o n G : N E G
INPUT
SETTING I N P U T S I G N A L : R G B
SET
SETTING I N P U T M E M O R Y N o . 0 2
INPUT
INFO.
SEL: SET:
Normal adjustment data block: The data during adjustment is
temporarily saved in this block. When you press the ENTER or
MEMORY key after adjustment, the adjustment data is stored in the
user data block.
Load
User data block
Save
I N P U T - A
Memory number of the loaded data
n N o . 1 1
ENTER EXIT: MENU
Memory number of the saved data
Normal
adjustment data
block
105
Adjustments (EN)