Sony VPH-G70Q Manuel D'installation page 29

When the switcher is connected to the projector using both the SIC-M or CCQ-BRS
connecting cable and the 5BNC cables (5BNC mode 1)
IFB-40 Signal Interface Board
SIC-M or CCQ-BRS
connecting cable
to REMOTE 1
OUT
Video
equipment
When you connect both the video and RGB signal input sources to the
switcher, use the SIC-M or CCQ-BRS connecting cable and the BNC
cables for connection between the projector and switcher.
IN
INPUT A S VIDEO TRIGGER CONTROL S
R
R-Y Y IN
P
R
G
C IN
Y
B
B-Y IN
P
B
IN
ABL LINK
SYNC
PLUG IN
OUT
HD POWER
IN
OUT
VIDEO
VD
IN OUT
OUT
5BNC cables
to MONITOR OUT
PC-1271/1271M
Switcher
HDTV/
Computer
Component
equipment
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors using the
5BNC cables.
Setting up
• Set INPUT-A to RGB and 5BNC MODE to ON in the SET SETTING
menu.
For details, see "The SET SETTING Menu" on page 51 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 45 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
Rear
REMOTE
RS-422A
INDEX
VIDEO IN
S VIDEO IN
to video to S Video
output output
Video
equipment
Computer
MAIN POWER
OFF ON
AC IN
100~120V 15A 250V
200V~240V T6.3A 250V
AC IN
AC power cord
(supplied)
to a wall outlet
29
Connections (EN)