Installation Procedures - Sony VPH-G70Q Manuel D'installation

Installation Procedures

4
(EN) Installation
By default, this projector is adjusted for 120-inch front projection on the
floor/desk. If you install the projector in other conditions, you have to
change some settings. Therefore, installation procedures depend on the
screen size or type, and installation method.
1 Verify the conditions of installation, such as angle of optical axis,
projection distance, height of the projector and screen.
.
2 Change the polarity according to the projection patterns. (page 19 (EN))
.
3 Install the projector and screen. (page 9 (EN))
.
4 Reset the registration data to factory setting. (page 108 (EN))
.
5 Adjust the CRT conversion angle. (page 21 (EN))
.
6 Adjust the lens focus and flapping of the lens. (page 64 (EN))
.
7 Adjust the magnetic focus and AQP (Axis Quadrupole)/DQP (Diagonal
Quadrupole). (page 68 (EN))
.
8 Adjust the registrations. (page 73 (EN))
.
9 Connect other equipment. (page 27 (EN))
.
0 Adjust each input signal. (pages 96 (EN) to 104 (EN))
• Fine adjustment for the magnetic focus and registrations.
(pages 96 (EN) and 100 (EN))
• Adjust the size or shift of the picture. (pages 98 (EN) and 101
(EN))
• Adjust the blanking. (pages 99 (EN) and 102 (EN))