For Remote Control; Preparation - Sony VPH-G70Q Manuel D'installation

For Remote Control

Preparation

38
(EN) Before adjustment
All adjustments, except focusing the lens and adjusting flapping of the
lens, can be made with the supplied remote control.
Normally, the adjustment keys on the remote control are inoperable to
prevent accidental adjustments. Cancel the protection before adjusting.
Since the remote control uses infrared, you can use it without a wire.
However, in order to correctly control the projector, you should connect the
remote control to the projector with the supplied remote control cable.
1
Insert three of the supplied R6 (size AA) batteries with the polarities
lined up correctly.
For details, see "Battery installation" on page 39 (EN).
2
Connect the remote control to the projector.
See "Connecting the remote control to the projector" on page 40 (EN).
3
Make sure that the COMMAND ON/OFF switch on the remote control
is set to ON.
4
Turn on the MAIN POWER switch on the projector, and then press the
POWER ON key on the remote control.
5
Open the panel cover of the adjustment keys.
PATTERN
Adjustment keys
Slide the cover while pushing it.
Lift the cover slightly to open.
LIGHT
MUTING STATUS COMMAND POWER
PIC AUDIO OFF ON OFF ON OFF ON
LCD LENS CONTROL RGB CENT
NORMAL ZOOM SHIFT FOCUS SIZE R MEMORY MENU
PATTERN SHIFT B
INPUT SELECT
VIDEO SELECT BLKG RESET ENTER
VIDEO/S VIDEO
PICTURE CONTROL
BRIGHT CONTR POSITION
A B C D
SWITCHER/INDEX
1 2 3 4
SHARP HUE COLOR VOLUME
5 6 7 8
SWITCHER
INDEX
9 0(ALL) SECOND
CUT OFF ADJ W/B FOCUS
R G B R G B BIAS GAIN MG FOCUS LENS
POSITION
REGISTRATION
CENT SIZE LIN SKEW BOW KEY PIN ZONE
COMMAND
ON/OFF
switch
POWER ON