Connecting Directly To The Projector - Sony VPH-G70Q Manuel D'installation

Connecting Directly to the Projector

When multiple input sources are connected to the projector
SYNC/HD
IFU-1271/1271M
IFB-12
to RGB input
to RGB output
Computer
You can expand the system connections by using the IFB-40 Signal
Interface Board which is installed to the projector by default, or in
combination shown in the examples below.
Use the IFU-1271/1271M Signal Interface Unit.
R
G INPUT A S VIDEO TRIGGER CONTROL S
R
R-Y Y IN
P
R
B G
C IN
Y
B
B-Y IN
P
B
IN
ABL LINK
SYNC
OUT
HD
IN
OUT
VIDEO
VD
VD
IN OUT
OUT
VIDEO OUT VIDEO IN
to video
to video input
output
to RGB output
Color
monitor
to RGB input
Color
monitor
Setting up
• Set INPUT-A in the SET SETTING menu to RGB.
For details, see "The SET SETTING Menu" on page 51 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 45 (EN).
• Switch the 75-ohm terminate connectors according to the connections of
the computer and color monitor.
For details, see "Switching the 75-ohm Terminate Connectors" on page 25
(EN).
Rear
REMOTE
RS-422A
INDEX
PLUG IN
POWER
S VIDEO IN
to S Video
output
Video equipment
MAIN POWER
OFF ON
AC IN
100~120V 15A 250V
200V~240V T6.3A 250V
AC IN AC power cord
(supplied)
to a wall outlet
27
Connections (EN)