HSP HanseShopping VARIO GYM Manuel D'instruction page 16

3. Insert the swing tubes (4) into the frarne (1) (one end at a time) and light
them using bolts (13) and lock washers (18) (2 per bolt), hold it with the Allen
wrench and tighten with the open end wrench. Repeat the procedure with
the opposite end.
4. Place the non-slip pedal (13) on the backpedal (5) and introduce the hexagonal screws (16) from top
to bottom. Fix them with the nuts (19) and lock washers (18) with the open end wrench. Repeat the
procedure with the other non-slip pedal.
UPPER PART ASSEMBLY
5. Once the lower part of the Vario Gym® is assembled, add the
handlebar and roller strip holding tube (6) by using the frame
knob (10) and the lock washer (22), fix it properly with the wing
nut (7).
6. Once the lower part of the Vario Gym® is assembled, add the handlebar
and roller strip holding tube (6) by using the frame knob (10) and the lock
washer (22), fix it properly with the wing nut (7).
Note: Make sure the rollers where the rubber band pass through are facing towards the inner side of
the roller strip holding tube curve.
7. Insert the handlebar height adjustment tube (9), into the handlebar and roller strip
holding tube (6) and hold with the knob and select the desired height.
8. Finally hook the stretching rubber bands to the loop of the tube (2A).
9. In case you wish to remove the upper part, reverse the process.
16