Adjusting The Speaker Output Levels; Before You Begin; Using The Test Tone (Test Dolby Sur.) - Yamaha RX-V1300RDS Mode D'emploi

ADJUSTING THE SPEAKER OUTPUT LEVELS

This section explains how to adjust the speaker output
levels by using the test tone generator. When this
adjustment is made, the output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound
field processor, and various decoders (Dolby Digital,
Dolby Pro Logic, Dolby Pro Logic , DTS, DTS ES, and
DTS Neo: 6).
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.

Before You Begin

NATURAL SOUND AV RECEIVER RX-V1300RDS
STANDBY
/ON
6CH INPUT MODE
A/B/C/D/E
TUNER
SPEAKERS BASS PROCESSOR
A B EXTENSION DIRECT
STEREO
DSP
2 3
1
Turn on the video monitor connected to this
unit.
2
Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
3
Set the BASS and TREBLE controls on the
front panel to the center position and turn off
BASS EXTENSION and PROCESSOR
DIRECT by pressing the buttons.
"BASS EXT. OFF" and "P. DIRECT OFF" appear
on the front panel display.
BASS TREBLE
– + –
24
0104V1300_21-25_EN-GB.p65
VOLUME
D I G I T A L
RDS MODE
PRESET/ PRESET TUNING
/FREQ EON PTY SEEK
TUNING /TUNING FM/AM MEMORY MODE BASS TREBLE
MODE START
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
PROGRAM
EFFECT
SILENT VIDEO AUX
– + –
3
SPEAKERS
A B
BASS PROCESSOR
EXTENSION DIRECT
Set to OFF.
+
24
Using the Test Tone (TEST DOLBY
SUR.)
Use the test tone to balance the output levels of the
speakers required for a surround sound system. The
adjustment of each speaker output level should be made at
your listening position with the remote control. After
completing the adjustments, use VOL +/– at your
listening position to check if the adjustments are
satisfactory.
4
2,5
+
1
Press AMP to select the
AMP mode.
AMP appears in the display
window on the remote control.
2
Press TEST to output the
test tone.
3
Adjust the volume of this
unit so you can hear the
test tone.
2002.11.07, 12:07
SELECT
POWER POWER AMP
1
TV AV
REC
AUDIO
+
DISC SKIP
3
VOL
–
LEVEL SET MENU MUTE
+
TITLE MENU
TV VOL
TV INPUT A/B/C/D/E
CH CH
TV MUTE
+
–
SELECT
PRESET PRESET
TEST ON SCREEN STEREO
TV VOL
–
RETURN DISPLAY
EFFECT
AMP
TEST
RETURN
+
VOL
–