Location And Connection - EUROM Valencia Manuel D'utilisation

Remote control:
Display:
1. Stand-by light
2. Day indicator
3. Temperature and thermostat setting
4. Time indicator and timer setting

Location and connection

 Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
 Do not use the fireplace before it has been completely installed according to the
instructions and you have read the instruction booklet fully!
 This device was designed to be permanently hung on a wall. Ensure the wall is
sturdy, completely vertical, is not sensitive to vibration and is not flammable.
Make sure it is not made of synthetic material and or covered with flammable
material. Be aware of pipes that may be contained within the walls when drilling
holes.
 Choose a suitable location for the fireplace, at least one metre from all
obstructions, walls and flammable materials (see safety instructions) and in the
vicinity of a 16 Amp (at least) fused, earthed electrical socket (protected by a
30 mA earth leakage circuit breaker). This socket must be located to the right of
the fireplace.
 There must be at least 30 cm distance between the base of the fireplace and the
ground, however, you are advised to place the fireplace at a height of 60 cm.
for the best sight. There must be at least 20 cm distance between the fireplace
and the side walls, at least 100 cm. between the fireplace and the ceiling. Do
A. ON/OFF button
B. Button for setting the time
C. + button
D. Erasing the time setting
E. Timer on/off button
F. Dimmer button
G. DAY and TIME button
H. - button
I. Automatic output selection
J. 1000W button
K. 2000W button
5. Lamps of 1000W - 2000W - auto
6. Dimmer setting
7. Operating timer light
8. Timer ON & OFF setting
38