Location And Connection - EUROM WOODLAND 2000 Mode D'emploi

Display
A. ON/OFF button
B. Button for setting the time
C. – button
D. Erasing the time setting
E. Timer on/off button
F. Dimmer button
G. DATE and TIME button
H. + button
I. Automatic output selection
J. 1000W button
K. 2000W button

Location and connection

 Remove the packaging materials and keep out of the reach of children. After
removing packaging, check device for damage or any evidence that may point
to a defect/failure. If in doubt, do not use the device but refer to your supplier
for checks/repairs.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 When you place wood in the wood compartment, make sure that suction
openings (f) are not blocked, see the illustration for description.
 Completely unwind the electrical cable and insert the plug into a suitable 220-
240V earthed socket. To prevent overloading, check that no other equipment is
connected to the same group.
Remote control:
1. Stand-by light
2. Day indicator
3. Temperature and thermostat setting
4. Time indicator and timer setting
5. Lamps of 1000W-2000W-auto
6. Dimmer setting Operating timer light
7. Operating timer light
8. Timer ON & OFF setting
36