Operating - EUROM Valencia Manuel D'utilisation

hangs on the wall supports and not on the little securing bracket!

Operating

 Check that the details on the data plate correspond to those of the electrical
supply which you wish to use for the fireplace. Do not use the same connection
for any other equipment.
 Install two AAA-1,5V batteries in the remote control.
 Check whether the main switch is set to OFF (O is pushed in)
 Now insert the plug into the grounded socket.
 Push the main switch to ON (I is pushed in). The heater is now on stand-by and
the light is switched on at the
 You can now further operate the fireplace with the remote control or with the
buttons on the fireplace itself.
Push-button operation:
If you don't use the remote control, you can press the relevant buttons on the
control panel, manually set it to 3 positions; the corresponding lights will turn on.
- I/O : flame effect only
- I/O + 1000W : flame display and heating at 1000W
- I/O + 2000W : flame display and heating at 2000 Watt (all the lights are turned
on).
By pressing the I/O button longer, you initiate the dimmer function; the light
intensity will increase or decrease with every tweet. Release the button when you
have achieved the desired intensity
Attention! The thermostat cannot be set manually, only with the remote control.
The thermostat is standard set to 20°C.
Remote control:
 Press on the ON/OFF button to switch on the heater.
 Now set the desired temperature. The temperature & timer setting will usually
show the ambient temperature. By pressing on the + or - button, you see the
set temperature flashing for a short time and by pressing the + or - buttons, you
can adjust the temperature (from 15 to 30°C). After a few seconds, the display
switches back to the ambient temperature and the newly desired temperature is
set. The temperature is standard set to 20°C.
 Now you can start operating the heater by pressing the button to 1000W (half
output) or 2000W (full output). When the set temperature is above the ambient
temperature, the heater will start to heat (1000W, 2000W). The corresponding
lights on the display are turned on (1000W-1 star, 2000W-2 stars).
If you press the IC button, the heater will automatically choose the most suitable
output. The corresponding lights on the display are turned on (IC-AUTO).
 The thermostat will switch off the heater as soon as the heater reaches the
desired temperature and it will switch it on again if the ambient temperature
drops.
Note: ensure that the weight of the fireplace
.
40