Location And Connection - EUROM Malmo Manuel D'utilisation

Display
a. ON/OFF button
b. Button for setting the time
c. – button
d. Erasing the time setting
e. Timer on/off button
f. Dimmer button
g. DATE and TIME button
h. + button
i. Open-window-detection
j. 1000W button
k. 2000W button

Location and connection

 Remove the packaging materials and keep out of the reach of children. After
removing packaging, check device for damage or any evidence that may point
to a defect/failure. If in doubt, do not use the device but refer to your supplier
for checks/repairs.
 The fireplace must be placed against a wall. Place the heater on a sturdy, flat
surface. The substrate must be heat-resistant. Make sure that the suction
openings are never blocked!
 Choose a suitable location for the fireplace, at least one metre from all
obstructions, walls and flammable materials (see safety instructions) and in the
vicinity of a 16 Amp (at least) fused, earthed electrical socket (protected by a
30 mA earth leakage circuit breaker).
Remote control:
1. Stand-by light
2. Day indicator
3. Temperature and thermostat setting
4. Time indicator and timer setting
5. Lamps of 1000W-2000W-Open Window-
detection
6. Dimmer setting Operating timer light
7. Operating timer light
8. Timer ON & OFF setting
37