Fitting Options; Fitting To The Floor; Minimum Clearances; Mounting On The Wall - Fronius Selectiva Plus E Instructions De Service

Fitting options

Fitting to the
floor
Fig. 2 Fitting to the floor
Minimum clea- Important! Observe minimum clearances for ventilation purposes. Ensure an adequate
rances supply of fresh air. To ensure an adequate supply of fresh air, leave a minimum gap of
50 mm to the left and right of the cooling vents.
Mounting on the
wall
Fig. 3 Mounting on the wall
370 mm
42 mm
(1)
(3)
(3)
(4)
Fit the charger to the floor using the
optional fitting brackets:
1.
2.
3.
4.
5.
Fit the charger to the wall using the
(2)
optional wall bracket:
1.
2.
(1)
3.
4
Insert the fitting bracket into the left
and right-hand sides of the ventilation
grille on the charger's front panel,
and do the same on the rear panel
Mark the location of the holes on the
mounting surface (see diagram for
measurements)
Drill holes
Select the most suitable screws for
fastening the charger according to
the nature of the mounting surface
(diameter 5 mm)
Fasten charger to the mounting
surface using fitting brackets, each
with two screws
Place the charger onto the bracket
(insert wall bracket lug (1) into slot on
the plastic front panel (2))
Fasten the charger to the bracket
using the two screws supplied (3)
(diameter 3.5 x 9.5 mm)
NOTE! If fixing to the wall, please
note the weight of the charger.
Only fix to a wall that is suitable
to this purpose.
The bracket is fitted using suitable
dowels and screws at the cut-outs (4)