Setup Menu; General Remarks; Navigating The Set-Up Menu; Set-Up Menu/Service Level 1 - Fronius Selectiva Plus E Instructions De Service

Setup menu

General remarks

The following parameters can be set in the Set-up menu:
-
-
-
-
-
-
Navigating the 1.
Set-up menu
2.
3.
3.
Set-up menu/
service level 1
Charging characteristic in accordance with the attached characteristic parameters
sheet
Battery capacity
Number of cells in the battery to be charged
Temperature-controlled charging
Electrolyte circulation
Specific charging characteristic parameters
NOTE! Risk of damage. The battery must not be connected to the charger
when setting parameters.
CAUTION! Setting the parameters incorrectly can result in product damage
and poor charging performance. Always set the parameters according to the
type of battery to be charged.
Access the Set-up menu
Set-up menu, service level 1
Set-up menu, service level 2
Selected service level display Press info button to continue
Navigate in the Set-up menu. Use the buttons as follows:
Save setting and go to next menu item
Move to next setting, e.g. for time setting (hh:mm:ss) move from hours (hh)
to minutes (mm)
Increase value
Reduce value
Charging characteristic
To set the required charging characteristic in accordance with the
attached charging characteristic parameters
Main charging voltage
To set the charging voltage (only for characteristics with settable
charging voltage)
Equalisation charging delay time
To set a delay time until the start of equalisation charging (only for
characteristics with equalisation charging)
Nominal values and the firmware version appear on the
display for 5 seconds. The charger then switches to
standby mode
+
for approx. 20 seconds
+
for approx. 40 seconds
12