Betamotor ALP 4.0 Mode D'emploi page 97

Page 6 - LAP – Stopwatch
minutes:seconds:tenths of a second
Page 7 - CLK - Clock
hours:minutes:seconds
Clock setting procedure
1. Press the MODE or SCROLL button until the hour digits start blinking.
2. Releasing the button and then pressing it again. increases the hours by one unit.
Holding down the button causes the figures to change rapidly. Leaving the button
inactive skips to step 4.
3. Release the button when the correct hour setting has been obtained.
4. After 2 seconds the minute digits start blinking.
5. Use the procedure described at step 2. Leaving the button inactive skips to step 8.
6. Release the button when the correct minute setting has been obtained.
7. After 2 seconds the second digits start blinking.
8. Use the procedure described at step 2.
9. Release the button when the correct second setting has been obtained. The new time
setting is stored after 2 seconds.
10. Changing the speed unit from Km/h to Mph causes the time display to change
from the 24-hour to the 12-hour format.
Pressing SCROLL for 1.5 seconds while page
5 is displayed brings up figure 21 for 1 sec-
ond with the bars
- - : - - :- - at the top.
Holding down SCROLL brings up page 5
again.
Releasing the SCROLL button brings up page
6.
Displayed information:
Stopwatch format
MINUTES:SECONDS 00:00
displayed at the top. Two small digits are used
for tenths of a second. It works exactly as page
5, of which it represents an extension.
When this page is reset, page 5 is also reset
and vice versa.
Instant speed on small digits (max. 199
km/h or Mph)
Pressing SCROLL for 1.5 seconds while
page 6 is displayed, brings up figure 21
for 1 second.
Holding down SCROLL brings up page 6
again.
Releasing the SCROLL button brings up page 7.
Displayed information:
Instant speed at the top (max. 199 km/h
or Mph)
Clock HOURS:MINUTES:SECONDS
at the bottom, 00:00:00.
The parameter can be adjusted by pressing
MODE or SCROLL while the vehicle is station-
ary.
If Km/h has been selected, the clock will oper-
ate in 24-hour format.
If Mph has been selected, the clock will operate
in 12-hour format.
PM added automatically when Mph is select-
ed.
97
1
23:59:59
11:59:59 with AM/
GB