Final Transmission Group Substitution - Betamotor ALP 4.0 Mode D'emploi

3
GB
FINAL TRANSMISSION GROUP SUBSTI-
TUTION
In case one of the three final transmission
components must be substituted because
of wear (pinion, chain and crown), it is
recommended to substitute the entire group.
Substituting the chain
• Use a screwdriver as shown in the fig-
ure.
• Remove the catch B on the links A, after
having located it and positioned it on the
crown.
• Remove the link and take the chain out
Note:
During reassembly proceed in the inverse
order, being careful to position the OR
correctly. The safety catch must be assem-
bled in the opposite direction of the tire
rotation (see figure).
138