Maintenance; Symptoms That Do Not Indicate Appliance Malfunctioning - Olimpia splendid Ci2 Instructions Pour L'emploi

4.2 - MAINTENANCE

If you do not intend to use the appliance for a long period of time, work as follows:
a. Activate the fan only mode for a few hours (approximately 8÷10 hours) to dry the interior of the appliance.
b. Stop the air appliance and disconnect the power supply.
c. Clean the air filter.
d. Remove the batteries from the remote control.
Checks before resuming use of the air conditioner:
a. Clean the filters after a long period of inactivity of the air conditioner.
b. Check that the air outlet or inlet are not obstructed (especially after a long period of inactivity of the air
conditioner).

4.3 - SYMPTOMS THAT DO NOT INDICATE APPLIANCE MALFUNCTIONING

SYMPTOM 1: The appliance does not work
a. The appliance does not start immediately when the ON/OFF key is pressed on the remote control.
The operating LED switches on, the system is in normal conditions. The appliance starts 3 minutes after
switch-on to prevent over-loading the compressor motor.
b. If the operating LED and the "PRE-DEF indicator (model with heat pump) or the ventilation indicator (cooling
only model) switch on, it means that heating mode has been selected. If the compressor does not activate
when the appliance is switched on, it is possible that the "anti cold air" protection is activated because the
outlet temperature is too low.
SYMPTOM 2: Passage to ventilation mode during operation in cooling mode
a. To prevent the internal evaporator from freezing, the system will automatically pass to ventilation mode, and
then go back to cooling mode shortly afterwards.
b. When the indoor temperature drops below the temperature set, the compressor stops and the appliance
passes to ventilation mode; when the temperature rises, the compressor resumes. This takes place in the
same way in heating mode.
SYMPTOM 3: White mist escaping from the appliance
Symptom 3.1
If the cooling function is started in a room with high humidity level an the inside of the appliance is very
contaminated, the distribution of the temperature is not regular. In this case, it will be necessary to clean the
inside of the appliance.
Contact your dealer for additional details regarding cleaning the appliance.
This operation requires a qualified professional.
Symptom 3.2
If the system passes from defrosting mode to heating mode, the humidity generated by defrosting is expelled
as a vapour.
> > > > >
EN - 21