Battery Status; Thorough Cleaning - Cembre B1300TEP Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2.4) Battery status

The battery is equipped with LED indicators that indicate the
remaining battery life at any time by pressing the adjacent but-
ton (P):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
Worklights illuminated combined with an alarm audible when the operating button (3) is
pressed, indicate that the battery voltage has dropped below a minimum safety threshold;
under these conditions the pump will not start, and it is necessary to recharge or replace
the battery.
The approximate time to fully recharge a battery is about 100 minutes.
After each working cycle, and after the extraction of the battery from the pump, an inte-
grated battery cut-off device will operate after 70 s approx.
Then the LED nearest to button (P) will fl ash 5 times every 14 s approx. The battery will be
reactivated when it is reintroduced into the pump and the operating button is pressed.
2.5) LED Worklights
While the tool is in operation, two high luminosity LED worklights switch on and switch off auto-
matically at the end of the cycle.
2.6) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
3. MAINTENANCE
The pump is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain its optimum performance:

3.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the pump must be wiped with a clean cloth taking care to remove any residue.
Do not use Hydrocarbons to clean the rubber parts.
After use, protect the couplers of the pump, hose and hydraulic head with their protective
caps to prevent contamination.
3.2) Storage case
(Fig. 10)
When not in use, the pump should be stored and transported in the plastic case, to prevent damage.
The case, type VAL P51, is suitable for storing the tool and accessories.
Val P51: Size 690x446x179 mm (27.2x17.5x7 inches). Weight 5,5 kg (12.1 lbs).
11
P

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

B1300tep-tB1300tepf

Table des Matières