Equipment Repair; Safety Precautions; Reference Standards; Personal Safety Precautions - Cristec CPS2 12V/16A Manuel D'utilisation

If appliances are in a dusty atmosphere, vacuum-clean them regularly, since dust deposits may adversely affect
heat release.
Check the state of battery charge every 3 months.
The tightness of nuts and screws should be checked annually to ensure efficient operation of the appliance
(particularly in hostile conditions: vibrations, shocks, high variations in temperature etc.).
A full technical inspection by a Cristec-accredited engineer is recommended every five years. This can also be
done at our plant.
6.3

EQUIPMENT REPAIR

Disconnect the battery charger from the AC power network and disconnect the batteries before undertaking any
repairs.
When fuses have blown, only use fuses of the type and size recommended in this manual.
Please contact a reseller or Cristec for any other repairs.
7

SAFETY PRECAUTIONS

7.1

REFERENCE STANDARDS

Class I equipment compliant with standard NF EN 60950
Installation instructions are set out in standard NFC 15-100 and the specific ISO13297 standard entitled
"pleasure boats – electrical systems – Installing distributed AC current".
7.2

PERSONAL SAFETY PRECAUTIONS

Only an electrician or professional installer should install the appliance.
The incoming AC power network should be cut off before working on the equipment.
7.3

PRECAUTIONS REGARDING THE RISK OF FIRE AND EXPLOSIONS

Only use the fuses listed herein.
Near batteries : keep the room well-ventilated, do not smoke, never use bare flames.
CPS2DEA.DOC 37