Precautions - Warranty; Precautions - Cristec CPS2 12V/16A Manuel D'utilisation

1 PRECAUTIONS – WARRANTY
The Cristec includes the following :
1 metal box containing the battery charger's electronic functions
This operating manual
This document applies to battery chargers in the CPS2 CRISTEC range as listed on the cover.
The manual is intended for users, installers and equipment maintenance staff. Please read this manual carefully
before working on the charger.
This manual should be kept safely and consulted before attempting any repairs, because it contains all the
information required to use the appliance.
This document is the property of CRISTEC; all the information it contains applies to the accompanying
product. CRISTEC reserves the right to modify the specifications without notice.

1.1 PRECAUTIONS

Precautions regarding overheating of the appliance
This appliance is designed to be mounted on a vertical wall or partition as indicated herein.
It is imperative that there be a gap of 150mm around the charger. The installer must see to it that the
temperature of the air at the input is lower than 40°C in extreme operating conditions.
Measures should also be taken to allow for the discharge of hot air on either side of the charger.
The charger must not be installed near a source of heat; it should be installed in a well-ventilated area. The
charger's air inlets and outlets must not be obstructed.
Precautions regarding dust, seepage and falling water
The charger should be located so as to prevent penetration of damp, liquids, salt and dust, any of which could
cause irreparable damage to the equipment and be potentially hazardous for the user.
The appliance should be installed in a dry and well-ventilated place.
Precautions regarding inflammable materials
The charger should not be used near inflammable materials, liquids or gases.
The batteries can emit explosive gases: please follow the manufacturer's instructions carefully when installing
them.
Precautions regarding accidental earthing leaks
The charger's PE terminal must be earthed and connected before any of the other terminals (see relevant
diagram in the appendix).
The charger must be closed before it is turned on: the cover and flap must be fixed to the charger's body with
the screw provided for the purpose.
Accidental leakage current between phase and earth: standard NFC15-100 should be followed when installing.
CPS2DEA.DOC 22