Cable Linking The Earth To The Installation; Precautions Regarding Electromagnetic Disturbance Generated By The Appliance - Cristec CPS2 12V/16A Manuel D'utilisation

Model
CPS2/12-16
CPS2/24-08
CPS2/12-25
CPS2/24-12
CPS2/12-40
CPS2/24-20
CPS2/12-60
CPS2/24-30
CPS2/48-15
CPS2/12-80
CPS2/24-50
CPS2/24-60
CPS2/24-75
CPS2/48-30
The installer should choose the type of cable (H07-VK, MX...) according to the type of application
and the applicable standards.
The cable bushings or glands must remain on the lower side of the case to avoid the linking cables
being damaged on the metal walls of the case and to guarantee insulation between the active
conductors and the electrical exposed conductive part.
See relevant drawing in the appendix.

4.2.4 Cable linking the earth to the installation

The charger's case should be connected to the installation's earthing system in accordance with current
standards governing the relevant application.
To that effect, connect the installation-to-earth cable to the earthing screw located inside the charger
(see drawing in appendix).
This cable's cross-section should be at least 2.5mm², type HO7-VK and equipped with an appropriate
terminal.

4.2.5 Precautions regarding electromagnetic disturbance generated by the appliance

Use shielded cables for all the connections (*). The shielding should be earthed at both the transmitting
and the receiving ends.
Keep cable length and shielding connections down to a minimum.
Route cables as close as possible to conductive parts ("loose" cables or loops should be avoided –
cables should be flattened against conductive parts).
Keep power cables separate from battery cables.
Keep power cables separate from control cables (at least 200mm).
Battery cable cross-
section
6 mm²
4 mm²
10 mm²
6 mm²
16 mm²
10 mm²
16 mm²
10 mm²
10 mm²
25 mm²
16 mm²
16 mm²
25 mm²
10 mm²
CPS2DEA.DOC
Diameter of the
terminal hole
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
5mm
33