Options - Cristec CPS2 12V/16A Manuel D'utilisation

The cables should only supply power to this appliance; any branch-offs or short-outs intended to power
another appliance are prohibited.
(*) This is a recommendation for installation rather than an obligation. The installing electrician should
decide whether or not to use shielded cable depending on the EMC environment.

4.2.6 Options

The options are not bundled with standard CPS2 battery chargers; they are available from your reseller.
Only options marketed by Cristec may be mounted with chargers.
The following options are available for the CPS2 range:
Remote On/Off charger control: reference A/M-CPS2
A 5-metre cable + On/Off switch; connect to K8 connector (see drawing in appendix)
Remote Boost control: reference BAD-CPS2
A 5-metre cable + Boost On/Off switch; connect to K11 (see drawing in appendix)
Night function (switches fan off) except for chargers CPS2/12-16 and CPS2/24-08 (no fans):
reference AR-VENT-CPS2
A 5-metre cable + On/Off switch; connect to K9 connector (see drawing in appendix)
ATTENTION: use of this function automatically reduces the output power to allow the fan to be
turned off. It should not be used permanently, otherwise the batteries run the risk of running down and
charger operation may be prematurely affected.
Temperature probe: reference STP-CPS2
Compensates the charging voltage according to temperature
12V Charger: -18mV/°C
24V Charger: -36mV/°C
48V Charger: -72mv/°C
A 5-metre cable + probe; connect to K2 (see attached drawing)
Digital display unit: reference SEEL007852B
Displays the state of the charger (ON/OFF), the current of the charger, the voltage on each of the 3
outputs
A 10-metre cable + display unit; connect to K3
Cables for analogue display units: reference DEP-V-A-CPS2
For connecting analogue voltmeter options (1 to 4 depending on the number of outputs to be
monitored: Bat D, Bat 1, Bat 2 or the voltage upstream of the distributor) and an ammeter
A 5-meter cable; connect to K10 (see drawing in appendix)
48x48mm analogue voltmeter to view the voltage of a particular output or the charger's voltage
upstream of the distributor
Reference: VLT0012-CPS2 for 12Vcc chargers
Reference: VLT0024-CPS2 for 24Vcc chargers
Reference: VLT0048-CPS2 for 48Vcc chargers
CPS2DEA.DOC 34