Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CRISTEC
3.2 Items supplied
CRISTEC supply items include the following elements:
1 metal case containing the battery charger electronic functions,
the present documentation (operating manual).
1 share of labels.
3.3 Additional supplies necessary for electrical installation
These items do not form part of CRISTEC's supply.
References to additional supply items which are necessary for correct operation of
the charger are defined in the following sections:
Any failure to comply with these provisions will result in cancellation of the
manufacturer's guarantee.
3.3.1. Cable connecting to the public mains supply or to an electricity generating set
Depending on line lengths, cables connecting to the ac mains supply MUST have a
cross-section equal to, or greater than, the values shown in the table below:
Model
CPS 600-1A
It is ESSENTIAL to use end-fittings with insulated sleeves (in accordance with standard
NF G 63-023) for connecting the mains input.
The PE conductor (commonly called "earth" green/yellow wire) of the ac source MUST
be connected to the charger on the terminal provided for this purpose.
3.3.2. Battery connection cable
Depending on line lengths, cables connecting to the batteries MUST have a cross-
section equal to, or greater than, the values shown in the table below:
Model
CPS 600-1A
It is ESSENTIAL to use the cable glands on the underside of the case in order to
prevent any damage to the cables on the metal edges of the case and to guarantee
double insulation between the live conductors and electrical earth.
CPS600DEA
Minimum cross-section
and types of cable for
115 Vac
3 x 2,5 mm² HO7-VK
Cross-section and type
of battery connection
cables
16 mm² HO7-VK
Minimum cross-section
and types of cable for
3 x 1,5 mm² HO7-VK
Type of terminal
Cross-section of cable and
diameter of the terminal hole
16 mm² - 5 mm
Page 27
230 Vac
Publicité
Chapitres
Table des Matières
