Mettler Toledo InPro 8600 Série Instructions D'utilisation page 5

InPro 8600 Series
How to use this instruction manual
InPro 8600 Series
52 800 991
This instruction manual is an integral part of the METTLER TOLEDO InPro 8600 sensors and
contains notes and instructions that are important for safety and operation.
All persons working on or with the InPro 8600 sensor must have first read and understood the
sections appropriate to the work in hand.
Please read this instruction manual carefully before using the InPro 8600 sensor. Keep this do-
cument close to the unit, so that operating personnel may easily be able to refer to it at any time.
Please first read section 1 "Introduction" and section 2 "Safety".
Proprietary designations
The following are proprietary names and, for the sake of simplicity, will be mentioned in this
instruction manual without the registration marking, e.g.
– InPro ® is a registered trade mark of Mettler-Toledo AG, CH - 8606 Greifensee, Switzerland.
Explanation of sensor designations
The general designation In Pro 8600 used in this instruction manual refers to the following turbi-
dity sensor models:
– InPro 8600 / D / *: version with digital interface
– InPro 8600 / W / *: version with wireless interface
– InPro 8600 / * / 1: single-angle version
– InPro 8600 / * / 2: dual-angle version
– InPro 8600 / * / 3: dual-angle plus colour version
® :
© 05 / 08 Mettler-Toledo AG, CH-8902 Urdorf
Printed in Switzerland
5