Editing Recorded Tracks; Erasing Tracks; To Erase A Track; To Erase The Whole Disc - Sony MZ-R55 Mode D'emploi

zEditing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
•Do not move or jog the recorder while "Toc
Edit"* is flashing in the display.
•You cannot edit tracks on an MD that is
record-protected. Before editing tracks,
close the tab on the side of the MD.
*TOC = Table of Contents

Erasing tracks

To erase a track

Note that once a recording has been
erased, you cannot retrieve it. Make sure
of the track you are erasing.
= +
1
Press EDIT/ENTER while playing
the track you want to erase.
" : Name" flashes in the display,
and the recorder plays the selected
track repeatedly.
2
Press = or + repeatedly until
" : Erase" flashes in the display.
3
Press EDIT/ENTER again.
"Erase OK?" and "Push ENTER"
appear alternately in the display.
To cancel erasing, press p or
T MARK.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
erase the part.
EDIT/ENTER
T MARK

To erase the whole disc

You can quickly erase all the tracks and
data of the MD at the same time.
Note that once a recording has been
erased, you cannot retrieve it. Be sure to
check the contents of the disc you want to
erase.
EDIT/ENTER
= +
1
Press EDIT/ENTER on the recorder.
2
Press = or + repeatedly until
" : Erase" flashes in the display.
3
Press EDIT/ENTER again.
"All Erase?" and "Push ENTER"
appear alternately in the display.
To cancel erasing, press p or
T MARK.
4
Press EDIT/ENTER again.
"Toc Edit" flashes in the display, and
all the tracks will be erased.
When erasing is complete, "BLANK
DISC" appears in the display.
T MARK
21-
GB