Setting The Clock To Stamp The Recorded Time - Sony MZ-R55 Mode D'emploi

Setting the clock to
stamp the recorded
time
To stamp the date and time on the MD
when you record, you first need to set the
clock.
=
1
Connect the power source.
Use the supplied AC power adaptor.
2
Press CLOCK SET at the bottom of
the recorder.
Use a pointed object.
The digits of the year flash.
3
Change the current year by pressing
= or +.
To change the digits rapidly, keep
pressing = or +.
4
Press ( to enter the year.
The digit of the month flashes.
5
Repeat steps 3 and 4 to enter the
current month, date, hour, and
minute.
When you press ( to enter the
minute, the clock starts operating.
16-
GB
+ ( p
CLOCK SET
(at the bottom)
If you make a mistake while
setting the clock
Press p, and set the clock again from step
2. You can skip a step by pressing (.
To display the current time
When the recorder is not operating or
while recording, press DISPLAY
repeatedly until the current time appears
in the display.
To display the time in the 24-
hour system
While setting the clock, press DISPLAY.
To display the time in the 12-hour system,
press DISPLAY again.
Charging the built-in battery for the
clock
When you use the recorder for the first time
or after a long period of disuse, charge the
built-in battery. After setting the clock, leave
the recorder connected to the AC power for
about 2 hours to charge the built-in battery.
Once charged, the built-in battery should last
about a month without connecting to any of
the power sources. The recorder will
automatically charge the built-in battery while
connected to AC power, dry batteries or a
rechargeable battery.