Keypad Operation - Steinberg Systems SBS-KW-300KC Manuel D'utilisation

KEYPAD OPERATION

They keypad includes those keys such as OFF, DIVISION COVERSION and ZERO.
(Note: The above keys can be used in sub-menu to set up Kg-lb conversion, Beep-
er On/Off, Zeroing and indicator exchange, etc.)
Model Max. Capacity(kg)
SBS-KW-300KC 300
SBS-KW-300KE
SBS-KW-300KE WR
LED & LCD
EN 1. Under weighing mode, press this key to display "OFF". Press it again
on the scale with LCD display, it will keep flickering "off". Press it
again on the scale with LED display, the red indication lamp
on the right window will keep flickering.
2. Press this key to change between Measured Division and Selectable
Division.
3. Press this key to set the current display to zero.
Under weighing mode of operation to turn on/off the display
backlighting (applicable to the scale with LCD display)
Mini. Weight (kg) Measured Division Selectable
2.0 0.10
10
Rev. 26.08.2020
GENERAL SCALE OPERATION
1. Turn On the Scale
a) Open the back cover of the scale casing - not applicable for the scale
SBS-KW-300KE WR.
b) Install 4 AA batteries and set the sliding switch to "B" position.
In case the scale is with rechargeable lithium battery (purchased option),
set the sliding switch to "A" position - not applicable for the scale
SBS-KW-300KE WR.
c) Close the back cover.
d) Press the mechanical switch located on the back of scale to power on.
e) After 0.0 is displayed and zeroing indicator (for LED model) or symbol
Div.
(for LCD model) is lit, the scale is ready for weighing operation.
0.05
(Note: it is recommended to allow scale 3~5 minutes of warm-up
time before starting weighing operation).
2. Zeroing
a) In general, the scale shows "0.0kg" or "0.00kg" after it is turned on.
In case the display is showing numerical value other than "0",
press
b) For LCD series crane scale, when "Aut" is set to "0" in the sub-menu,
the backlighting is turned on after
more than 3 seconds. Press and hold
the backlighting is turned off. If "Aut" in the sub-menu is set to "1",
the backlighting is turn on automatically when there is load added to
the scale and off after the weight being removed.
3. Weight Measurement
a) Once the load is suspended completely, the display shows the weight
value of the load. When the "Stable" indicator is lit, weight value can
be recorded.
b) In case there is tare such as cable, load the tare and press
zero the display to "0"kg. The weight value after this will be the net
weight. This will not change until the tare change or the scale being
turned off.
4. Turn Off the Scale
a) After weighing operation, the scale should be turned off. Press "OFF" on
the front keypad to stop weighing mode.
b) Then press the mechanical red switch on the back of scale to power turn
off the scale completely to prevent the leakage of the battery.
Rev. 26.08.2020
to set the display to "0".
key is pressed and hold for
key for another 3 seconds,
11
EN
to