Burkert 3232 Manuel D'utilisation page 15

Type 3232, 3233, 3233 K, 3234,
3235, 3239
8.2.2. Installation position T-valve Type 3234
For the installation of the T-valves into circular pipelines, we recommend
the following installation positions:
When media is supplied:
Fig. 7: Installation position type 3234
8.2.3. Installation position Y-valve Type 3239
For the installation of the Y-valves into systems, we recommend the
following installation positions:
When media is supplied:
Fig. 8: Installation position type 3239
Installation
When media is removed:
When media is removed:
8.2.4. Installation of the tank bottom valve
Type 3235
For further information on containers and welding instructions,
please refer to the standard ASME VIII Division I.
It is recommended to weld the valve prior to the container
installation. However, it is possible to weld the valves to ready-
assembled containers.
Prior to welding, please check to ensure that:
• The tank bottom valve does not collide with other equipment compo-
nents and assembly/disassembly of the actuator is always possible.
• A minimal distance between two welding joints three times the
thickness of the container wall is adhered to.
It is recommended to weld the valve in the center of the drain
to ensure optimum draining of the container.
The diameter of the hole in the container and the flange must be equal.
The valve has two welding edges to make welding and positioning of
the valve easier. The length of the welding edges is approximately 3
mm. In case the thickness of the container wall exceeds 3 mm, the
valve must be positioned as shown in Fig. 9.
→
Prior to welding the valve, grind the outlet wall.
english
15