Operation With The Buttons On The Tv - Salora 55UHC9102MS Mode D'emploi

TV Control Buttons & Operation
1. Standby On/Off button
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons

Operation with the Buttons on the TV

Press button to decrease the volume or
button to increase the volume, so a volume level scale
(slider) will be displayed on the screen. Press P/CH +
button to select the next programme or P/CH - button
to select the previous programme.
Press the or
to view the main menu. In the Main menu select a
sub-menu using TV/AV button and set the
sub-menu using
To see what options are available via the
menu, refer to the menu system section of
this manual. Press the TV/AV button in the
control panel on the TV to switch between
AV modes.
Note: Function indications of the buttons will
be displayed on the screen when pressed.
Operation with the Remote Control
Press the MENU button on your remote
control to display the main menu screen. Use the "
" or " " buttons to select a menu tab and press the
OK button to select option. Use the " " or " " or " "
or " " buttons to select or set an item. Press BACK
or EXIT or MENU button to quit a menu screen.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press
the "SOURCE - " button on your remote control
consecutively to select the different inputs.
Changing Channels and Volume
You can change the channel and adjust the volume
by using the V+/- and P+/- buttons on the remote. You
can also change the channels by pressing the buttons
on the front panel of your TV.
button at the same time
or buttons.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable/Satellite Connection
Connect the aerial or cable TV plug to AERIAL INPUT
(ANT-TV) or satellite lead to LNB INPUT(ANT SAT)
socket located on the rear bottom side of the TV.
Rear bottom side of the TV:
Notification
Manufactured under license from Dolby Laboratories.
TRADEMARK ACKNOWLEDGMENT
"Dolby" and the double-D symbol are trademarks of
Dolby Laboratories.
"HDMI, the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of
HDMI Licensing LLC."
English - 34 -
Aerial or Cable