Power Off - Salora 55UHC9102MS Mode D'emploi

Wait until they cool down, and contact the shop
where you purchased the product.
• Do not nail, hammer, or step on the battery.
Doing so may cause a short circuit, leading to
overheating, cracking, or fire.
• Do not overheat, disassemble, or short-circuit the battery,
or throw it into fire.
Doing so may cause cracking or fire.
• Do not connect the battery with metal items such as wires.
Also, do not carry or store the battery with metal items such
as necklaces or hairpins.
Doing so may cause a short circuit, leading to
overheating, cracking, or fire.
• Battery may present a risk of fire or explosion.
Warning, battery may explode if Mistreated. Do not
recharge, disassemble or dispose of in fire.
• Dispose of used battery promptly. Keep away from children.
Do not ingest the battery, Chemical Burn
Hazard. This product contains a coin/
button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death. Keep
new and used batteries away from children. If the
battery compartment does not close securely, stop
using the product and keep it away from children. If
you think batteries might have been swallowed or
placed inside any part of the body, seek immediate
medical attention.
Caution
About handling the 3D glasses
• Do not wear the 3D glasses for any purpose other than
viewing 3D programming.
3D glasses do not function as sunglasses.
• Do not use the 3D glasses if they are not working properly
or broken.
Continuing to use them in such a state may cause
injury, eye strain, or indisposition.
• Do not stand or walk while wearing 3D glasses.
You may lose your balance which could result in falls
or other accidents.
• Do not scratch the surface of the lenses with sharp objects.
• Do not drop or bend the 3D glasses.
• If your nose or temple turns red, or you feel pain or
discomfort, stop using the 3D glasses.
Such symptoms as above may occur if you keep
wearing them for a long time, which may also cause
indisposition.
• Be careful not to pinch your fingers in the hinge of the
3D glasses.
WARNING
3D Glasses
LCD Lens
Glasses Pairing Operation Instruction
These 3D Active glasses use Bluetooth wireless
technology. It is recommended to pair the TV to
the glasses before using to view 3D, as to prevent
interference from other Bluetooth devices. After
pairing the glasses will only work with the TV they
are paired to. There is no need to repeat this process
once successful pairing is complete unless you wish
to use with another TV.
To pair the glasses and TV:
1. Ensure TV is in 3D mode and glasses are within
0.5M of the TV.
2. In power on or power off state, press the power
button for 3 seconds. The LED light will flash
red and green whilst pairing is in progess.
Pairing success is indicated by the 3D glasses
shutters operating normally and the 3D content
can be viewed.
3. If the glasses cannot successfully pair with the
TV, the LED indicator will light red. If this is the
case, repeat steps 1 and 2 above.
Replacement of battery
• Push the spring clasp to the left, at the same time
move the battery lid up as indicated in picture 1.
• Pull the battery lid up. Install or replace the battery
as indicated in picture 2 observing correct polarity.
• Close the battery lid as shown in picture 3.
picture 1
Operation Instruction and
Function of Power LED Light
Power on
• Ensure TV is in 3D mode
• Press the power button on the glasses
• The LED light will flash red. Glasses are now in
ON state

Power off

• Press the power button on the glasses
• The LED light will flash red. Glasses are now in
OFF state
English - 49 -
Spring
clasp
Battery lid
Power button
/ LED light
picture 2 picture 3