Remote Control Handset; Inserting Batteries; Switching On/Off; To Switch The Tv On - Salora 32LED 7115CDW Mode D'emploi

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50
Hz.
• Press STANDBY touch button. Then the standby
LED lights up.
• To switch on the TV from standby mode either:
• Press the " " button, P+ or P- or a numeric button
on the remote control.
• Press the -P/CH or P/CH+ touch button on the TV.
The TV will then switch on.
Note: If you switch on your TV via P+ or P- buttons on
the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the " " button on the remote control or hold
the on the TV until shut down, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
Digital Teletext
• Press the " " button.
• The digital teletext information appears.
• Operate it with the coloured buttons, cursor buttons
and OK button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on the digital teletext
screen.
• When the "
television broadcasting.
• With digital broadcasting (DVB-T-C), in addition to
digital teletext broadcasting together with the normal
broadcasting, there are also channels with just digital
teletext broadcasting.
• The aspect ratio (picture shape) when watching
a channel with just digital teletext broadcasting is
the same as the aspect ratio of the picture viewed
previously.

Input Selection

Once you have connected external systems to
your TV, you can switch to different input sources.
Press "SOURCE" button on your remote control
consecutively for directly changing sources.
Note : YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Volume Setting

• You can move the control switch upward or
downward for changing the volume. To increase
volume, please move the switch upward. Move the
switch downward to decrease the volume. A volume
level scale (slider) will be displayed on the screen.
English - 52 -
" button is pressed, the TV returns to
(optional)