Bucking A Log - Oregon CS300 Manuel D'instruction

OREGON® Cordless Tool System
CHAIN SAW MODEL CS300

BUCKING A LOG

CAUTION: BUCKING LOGS UNDER
TENSION INCREASES THE CHANCE OF
KICKBACK. Use one of the methods below
to support the log when bucking.
Bucking is cutting a log into lengths . It
is important to make sure footing is firm
and weight is evenly distributed on both
feet . When possible, the log should be
raised and supported by the use of limbs,
logs or chocks .
• When the log is supported along its
entire length, cut from the top
(overbuck) (Fig . 37) .
FIG. 37
LOG IS SUPPORTED
ALONG ITS ENTIRE LENGTH
CUT FROM TOP (OVERBUCK)
AVOID CUTTING EARTH
• When the log is supported on one end,
cut 1/3 the diameter from the underside
(underbuck), then make the finished cut
by overbucking to meet the first cut
(Fig . 38) .
FIG. 38
LOG IS SUPPORTED ONE END
2ND CUT OVERBUCK (2/3 DIAMETER)
TO MEET 1ST CUT (TO AVOID PINCHING)
1ST CUT UNDERBUCK (1/3 DIAMETER)
TO AVOID SPLINTERING
AA 1214 - F/N 573259
OPERATING THE SAW
• When the log is supported on both
ends, cut 1/3 of that diameter from the
top overbuck, then make the finished
cut by underbucking the lower 2/3 to
meet the first cut (Fig . 39) .
FIG. 39
BUCKING A LOG
1ST CUT OVERBUCK (1/3 DIAMETER)
TO AVOID SPLINTERING
2ND CUT UNDERBUCK (2/3 DIAMETER) TO
MEET 1ST CUT (TO AVOID PINCHING)
• When bucking on a slope, always stand
on the uphill side of the log (Fig . 40) .
FIG. 40
BUCKING ON A SLOPE
STAND ON UPHILL SIDE
WHEN CUTTING BECAUSE
LOG MAY ROLL
• To maintain complete control when
cutting through, release the cutting
pressure near the end of the cut without
relaxing the grip on the chain saw
handles .
• Don't let the chain contact the ground .
• After completing the cut, wait for the
saw chain to stop before you move the
chain saw .
• Always stop the motor before moving
from tree to tree .
27