Unpacking And Assembly; What's In The Box; Checking The Front Hand Guard Position - Oregon CS300 Manuel D'instruction

OREGON® Cordless Tool System
CHAIN SAW MODEL CS300

UNPACKING AND ASSEMBLY

UNPACKING
DANGER: TO AVOID SERIOUS
PERSONAL INJURY, DO NOT OPERATE
THE CHAIN SAW WITHOUT THE GUIDE
BAR, SAW CHAIN AND SIDE COVER
PROPERLY ASSEMBLED.
WARNING: DO NOT ATTEMPT TO
OPERATE THE CHAIN SAW IF ANY
PART IS DAMAGED OR MISSING.

WHAT'S IN THE BOX?

The chain saw requires some assembly
before use . These items ship with the
chain saw:
• Powerhead
• Guide bar
• Saw chain
• Blade cover
• Chain tensioning gear
• Chain tensioning o-ring
• Chain tensioning screw
• Bar and chain oil
• Charger and power cord (if so equipped)
• Battery (if so equipped)
After removing the chain saw from the
box, inspect it carefully to ensure no
damage has occurred during shipping,
and that no parts are missing . If any parts
are damaged or missing, do not use the
chain saw . Contact OREGON® Cordless
Tool System at 888 . 3 13 . 8 665 to obtain
replacement parts .
AA 1214 - F/N 573259
UNPACKING AND ASSEMBLY
CHECKING THE FRONT HAND
GUARD POSITION
After unpacking the chain saw, check the
position of the front hand guard . The
chain saw will not run with the chain
brake engaged . Pull the front hand guard
back towards the front handle before
operation (Fig . 7) .
FIG. 7
FRONT HAND GUARD
IN BRAKE POSITION
FRONT HAND GUARD
IN OPERATING POSITION
15