Connecting The Extension Hosepack - Fronius TTB 80 G Instructions De Service

Connecting the The extension hosepack is supplied with a protective bag, in which the interface between
extension the extension hosepack and the torch hosepack must be laid.
hosepack
1
2
3
4
5
A
* Velcro strips on the inside pocket (inside pocket not
shown)
44
Position the protective bag so that the Fronius logo is visible and the loops are at the
top:
left = power source side (A)
right = welding torch side (B)
Open the protective bag:
- Position both zip pulls to the right as far as they will go
- Pull the bottom tape end out of the zip pulls
Connect the power/gas connections of the extension hosepack and the torch
hosepack to one another (bayonet latch)
Place the interface in the inside pocket of the protective bag
*
1
NOTE!
When performing the following activi-
ties, ensure that the cables and hoses
are not trapped, kinked, cut, or other-
wise damaged.
Secure the interface in the inside pocket
with 2 Velcro strips
B
*
2
2x