Installation Guide - AMIX SPL 25 Manuel Utilisateur

INSTALLATION GUIDE

It is good practice to plug in all the equipments before power on.
A/ Connections:
 Plug in CAP65 sensor to SPL25.
 Connect SPL25 to the power supply
 For the first time, plug SPL25 directly to your computer using the RJ45 port (LAN on the front
panel). Attention, use a cross RJ45 wire.
 If you intend to use the dry loop outputs, use an other RJ45 wire.
Connect GPOI/GPO2 outputs to the remote equipment such as AFF05 display etc...
Otherwise make no connection.
CAP65
PS 12V
SPL25
SPL25 internal memory
setting, reading and analysis.
B/ Starting:
 Stand alone:
SPL25 features a web server allowing to control from you favorite web browser. Open your
browser, enter SPL IP address into the address window.
Default factory IP address is : 192.168.0.25.
http://
You can now access the web pages to set, analyse and read the SPL internal memory.
Attention, in case of difficulties, follows the procedure in "technical tools" annex
 Use on a net :
Connect SPL25 to the net using the RJ45 connector.
Attention : To work properly the SPL IP address should be unique on the network, and in the
available IP range. Should the PC or router net differ from SPL25, first modify PC or router to
the same net as SPL25, then set SPL IP address as described in "technical tools" annex.
AMIX
GPO1/GPO2 OUT
To connect an AFF04 display
192.168.0.25
PS 12V
SPL25
SPL25 internal memory
setting, reading and analysis.
32
CAP65
GPO1 OUT
GPO2 OUT
to connect external
equipment such a
spot
SPL25