AMIX SPL 25 Manuel Utilisateur page 33

INSTALLATION GUIDE
C/ Lost IP address:
If you cannot remember the SPL IP address, use the following procedure:
 Have something to write the IP address. Plug and disconnect two times the sensor-micro
plug (6 points removable connector on SPL25 front panel). This will display the IP
address using GPO1 and GPO2 leds. GPO1 led gives IP address and GPO2 shows the
points between the numbers.
Example :
"1": GPO1 led blinks once, then blank.
"2": GPO1 led blinks twice, then blank.
"9": GPO1 led blinks nine times, then blank.
"0" : GPO1 led blinks for a while, then blank.
"." : GPO2 led blinks once, then blank.
For instance : IP Adress : 192.168.0.96
GPO1 led blinks once, then
GPO1 led blinks nine times,
then GPO1 led blinks twice
GPO1 led blinks once, then
GPO1 led blinks six times,
then GPO1 led blinks eight
times.
GPO1 led blinks for a while
GPO1 led blinks nine times,
then GPO1 led blinks six times
AMIX
GPO2 led blinks once
GPO2 led blinks once
GPO2 led blinks once
1 9 2 . 1 6 8 . 0 . 9 6
33
RJ45 on SPL25 3
GPO1
GPO2
Next
SPL25