Replaying Music Pieces; Replaying Only The First Few Seconds Of A Title - IMG STAGELINE MPX-40DMP Mode D'emploi

3) Adjust the headphone volume with the con-
GB
trol LEVEL (16).
4) To monitor the sum signal, set the MIXING
control to the position MASTER. In the inter-
mediate positions, a mixed signal from the
input channel signal and the sum signal is
reproduced.
6 Operation of the MP3 Player
After switching on the unit, the MP3 player will
load the USB storage medium connected to the
USB port (9). If no USB storage medium has
been connected, the display (11) will show "NO
USB" after a while.

6.1 Replaying music pieces

1) Insert a USB flash drive into the USB port (9)
or connect a hard disk (with separate power
supply, if necessary) to the USB port
and / or
insert an SD/ MMC memory card into the slot
SD (10), the notched corner of the card facing
to the left. To remove the card, slightly press
it to eject it.
2) Select the memory card or the USB storage
medium with the button USB / SD (33), if nec-
essary. Accordingly, the display (11) shows
USB or SD (A) on the top left.
3) After loading, the first title in the first folder is
selected. To start the first title, press the but-
ton (31). To pause and continue the
replay at any time, press the button
4) To select another title, use the buttons
(32). The display shows the title number
under TRACK (G).
Button : to go to the next title
Button : to go to the beginning of the cur-
rent title. Each time you press the button, you
go back another title.
5) To select another folder, press the button
FOLDER / TRACK (27) first so that it is illumi-
nated. Now select another folder with the but-
tons and . The display shows the num-
ber of the folder under FOLDER (H).
To use the buttons
selection again, press the button FOLDER /
TRACK once again so that it no longer illumi-
nated.
6) For fast forward, keep the button
for fast reverse, keep the button
(The button FOLDER / TRACK must not be
illuminated.)
Note: You will not be able to trace the fast forward /
reverse function acoustically, only by means of the
time indication on the display. Fast reverse always
stops at the beginning of the title.
7) To change the replay speed and thus the
pitch, the button PITCH (35) must be illumi-
nated. If it is not illuminated, press the button
once. To change the speed by ±16 % in steps
of 1 %, press the button PITCH (26). The dis-
play shows the deviation from the standard
speed under PITCH (O).
10
6.2 Indication of title information
The display (fig. 2) indicates a variety of infor-
mation:
1. The number of the folder selected under
FOLDER (H).
2. The number of the title selected under TRACK
(G). In each folder, the titles are numbered
separately.
3. The playing time of the title selected: relative
as a bar graph (D) and absolute in minutes
and seconds (N); the seconds are divided
into 75 frames
To select the playing time indication, press
the button TIME (39):
ELAPSED (C) to indicate that the time already
played of the title is displayed
REMAIN (E) to indicate that the remaining time
of the tile is displayed
4. The file name scrolling through the text line
(L); if there is additional information on the
title (ID3 tags), e. g. name of the title, artist
and album, this information is also indicated
in the text line
6.2.1 Graphic indication of playing time
In addition to the numerical time indication (N),
the bar graph (D) indicates the playing time
graphically by its length, in relation to the title
duration (relative time indication). To indicate the
last 30 seconds of a title, the bar graph starts
flashing in its full length.
.
and
6.2.2 Number of beats per minute
To determine the number of beats per minute of
a title, briefly press the button TAP (38) several
times to the beat of the music. The display
shows the number of beats under BPM (F).
6.3 Selecting continuous replay
or single title replay
To switch between continuous replay [indication
CONTINUE (K)] and single title replay [indication
SINGLE (J)], press the button CONT/ SINGLE (34).
1. For single title replay the unit is always set
and for title
to pause at the end of a title.
This mode is specially provided for DJ
applications. After selecting a title, the MP3
player is set to pause precisely on the spot
pressed;
where the music starts (usually not at the time
pressed.
index 0 : 00 : 00 but some frames later, e. g.
0 : 00 : 15). This spot is automatically memo-
rized as a starting point (Auto Cue point). On
the display, it is indicated as CUE (I). After
starting the title, press the button CUE (30) to
return to this starting point. After replaying a
title, the unit is set to pause precisely on the
spot where the music of the next title starts.
This spot is then memorized as a new start-
ing point.
2. For continuous replay all titles are played
continuously one after the other, i. e. after the
last title, the first title starts again.
6.4 Replaying only the first few seconds
of a title
For replaying only the first few seconds of a title,
keep the button CUE (30) pressed. After releas-
ing the button, the MP3 player returns to the
beginning of the title and is set to pause.
1) Set the player to single title replay: indication
SINGLE (J). If CONTINUE (K) is indicated, press
the button CONT/ SINGLE (34).
2) Select the title (chapter 6.1, steps 4 and 5).
3) When the display shows CUE (I) and the but-
ton CUE is illuminated in red, keep the button
pressed to replay only the first few seconds of
the title.
4) To replay the title, press the button
6.5 Return to a certain spot defined
previously (Cue point)
To quickly return to a certain spot within a title,
memorize a starting point (Cue point) with the
button CUE (30).
1) While replaying, when you have reached the
spot to which you wish to return to later, set
the unit to pause with the button
2) Restart the replay with the button
spot is memorized as a Cue point. To con-
firm, the indication AUTO CUE (I) and the but-
ton CUE start flashing twice.
Caution: Do not set the player to pause
again now; otherwise the spot memorized as
a Cue point will be replaced by the spot
where the player was set to pause when the
replay is continued.
3) To return to the Cue point, press the button
CUE. After returning, the button is illuminated
and the display shows CUE (I). The MP3
player is set to pause.
4) Start the replay with the button
button CUE pressed as long as the title is to
be played. After releasing the button CUE,
the MP3 player returns to the Cue point and
is set to pause.
Note: When you have reached or selected the next title,
the Cue point that has been memorized will be replaced
by the beginning of the next title.
6.6 Effects
Various effects are available for a creative music
programme.
1. Brake: This effect simulates the slow start
and braking of a turntable.
To activate the effect, press the button
BRAKE (37) so that it is illuminated. When a
music piece is replayed and you set the unit
to pause with the button (31), the replay is
not stopped abruptly, but is braked to a
standstill. When you continue the replay, the
title starts slowly.
2. Reverse: reverse replay
Press the button REVERSE (36) when a title
is replayed.
Note: For technical reasons, you will only be able to
replay a title in reverse mode for the same time that
it has been replayed in forward mode.
(31).
(31).
. The
or keep the